Kenwood KDC-X302 Instruction Manual

Kenwood KDC-X302 Instruction Manual Manual pdf 39 page image

ENGLISH 35Source name Display information/ /STANDBY Source name (*2) Clock (back to the beginning)RADIO Frequency (*2) Clock (back to the beginning)(For FM Radio Broadcast Data System stations/FM Radio DataSystem stations only)Station name (*2) Radio text Radio text+ Title/Artist FrequencyClock (back to the beginning)CD or USB (For CD-DA)Disc name/Artist (*2) Track title/Artist Playing time Clock(back to the beginning)(For MP3/WMA/AAC/WAV/FLAC files)Song title/Artist (*2) Album title/artist Folder name File namePlaying time Clock (back to the beginning)iPod USB/iPod BT orANDROIDWhen [MODE OFF]/[BROWSE MODE] is selected ( 9):Song title/Artist (*2) Album title/Artist Playing time Clock(back to the beginning)PANDORA/PANDORA BT(For / )Station name (*2) Shared/Radio station Song title ArtistAlbum title Playing time Clock (back to the beginning)IHEARTRADIO (For / )Station name (*2) Song title/Artist Clock (back to the beginning)SPOTIFY/SPOTIFY BTContext title (*2) Song title Artist name Album namePlaying time Clock (back to the beginning)BT AUDIO Song title/Artist (*2) Album title/Artist Playing time Clock(back to the beginning)AUX Source name (*2) Clock (back to the beginning)* 2 Only for : Turn off the display information.REFERENCES INSTALLATION/CONNECTIONWarning• The unit can only be used with a 12 V DC power supply, negative ground.• Disconnect the battery’s negative terminal before wiring and mounting.• Do not connect Battery wire (yellow) and Ignition wire (red) to the car chassis or Ground wire(black) to prevent a short circuit.• To prevent short circuit:– Insulate unconnected wires with vinyl tape.– Be sure to ground this unit to the car’s chassis again after installation.– Secure the wires with cable clamps and wrap vinyl tape around the wires that come intocontact with metal parts to protect the wires.Caution• For safety’s sake, leave wiring and mounting to professionals. Consult the car audio dealer.• Install this unit in the console of your vehicle. Do not touch the metal parts of this unit duringand shortly after use of the unit. Metal parts such as the heat sink and enclosure become hot.• Do not connect the [ wires of speakers to the car chassis or Ground wire (black), or connectthem in parallel.• Mount the unit at an angle of less than 30º.• If your vehicle wiring harness does not have the ignition terminal, connect Ignition wire (red)to the terminal on the vehicle’s fuse box which provides 12 V DC power supply and is turnedon and off by the ignition key.• Keep all cables away from heat dissipate metal parts.• After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car areworking properly.• If the fuse blows, first make sure the wires are not touching car’s chassis, then replace the oldfuse with one that has the same rating.Basic procedure1 Remove the key from the ignition switch, then disconnect the [ terminal of the carbattery.2 Connect the wires properly.See Wiring connection ( 37).3 Install the unit to your car.See Installing the unit (in-dash mounting). ( 36)4 Connect the [ terminal of the car battery.5 Press to turn on the power.6 Detach the faceplate and reset the unit. ( 3)