Kenwood KDC-X7533U Instruction Manual

Also see for KDC-X7533U: Instruction manual Service manual

Kenwood KDC-X7533U Instruction Manual Manual pdf 29 page image

English | 29In Standby modeBuilt-in Amp SettingControlling the built-in amplifier.Turning OFF this control enhances the preoutquality.Display Setting"AMP ON" The built-in amplifier activates."AMP OFF" The built-in amplifier deactivates.Other than Standby mode/When the Dual Zone System is ONDual Zone System SettingSetting the Front channel and Rear channelsound in the Dual Zone System.Display Setting"ZONE2 R" Sub source (Auxiliary input source) is to be rearchannel."ZONE2 F" Sub source (Auxiliary input source) is to be frontchannel.Other than Standby modeB.M.S. (Bass Management System)Adjust the bass boost level of the externalamplifier using the main unit.Display Setting"BMS FLT" Bass boost level is flat."BMS +6" Bass boost level is low (+6dB)."BMS +12" Bass boost level is mid (+12dB)."BMS +18" Bass boost level is high (+18dB).• Refer to the catalog or instruction manual for poweramplifiers that can be controlled from this unit.• For amplifiers, there are the models you can set fromFlat to +18 dB, and the models you can set from Flatto +12 dB.When an amplifier that can only be set to +12 isconnected to the unit, "BMS +18" will not workcorrectly even if it is selected.Other than Standby modeB.M.S. Frequency OffsetSetting the central frequency, boosted by B.M.S.Display Setting"BMSF NML" Boost with the normal central frequency."BMSF LOW" Drop the normal central frequency 20%.When LX AMP unit connectingAMP ControlYou can control the LX AMP connected to theunit.1 Select AMP Control modePush the Control knob towards [FM] or [AM].Select the "AMP CTRL" display.2 Enter AMP Control modePress the Control knob for at least 1 second.3 Select the AMP Control item for adjustmentPush the Control knob towards [FM] or [AM].• For the details on the AMP Control item, see theInstruction manual attached to the LX AMP.4 Adjust the AMP Control itemPush the Control knob towards [4] or[¢].5 Exit AMP Control modePress the [MENU] button.• You cannot use the LX AMP operation during standbymode.