12|EnglishGeneral featuresSubwoofer OutputTurning the Subwoofer output ON or OFF.Hold down on [AM] of the Control knob for atleast 1 second.Each time you push the knob, Subwoofer outputswitches ON and OFF.When it is ON, "SUBWOOFER ON" is displayed.• You can control this function when "2ZONE" of• You can control this item when Speaker SelectSubwoofer of (page13) is set to any item other than "None".Sound Field Control1Select the source to adjustPress the [SRC] button.2Show the Multi-function displayPress the [NEXT] button repeatedly until"S.F.C" appears.Refer to (page9).3Enter Sound Field Control modeTurn the [VOL] knob to select "S.F.C".Press the [VOL] knob.• To get the best sound, first set the Cabin Settingand Speaker Select Front/Rear parameters using the (page 13).• When "2ZONE" of cannot select "S.F.C".4Select the Sound Field Control item toadjust1Turn the [VOL] knob to select the item youwant to select. Press the [VOL] knob.2Press the Control knob.3Push the Control knob towards [FM] or[AM].123Sound Field control item"X'Over" "HPF Front""fc""SLP"Front High Pass Filter FrequencyFront High Pass Filter Slope"HPF Rear"*¹ "fc""SLP"Rear High Pass Filter FrequencyRear High Pass Filter Slope"LPFSubWoofer"*²"fc""SLP""Phase"Subwoofer Low Pass Filter FrequencySubwoofer Low Pass Filter SlopeSubwoofer Low Pass Filter Phase"DTA""DTA Front"DTA Front"DTA Rear"*¹DTA Rear"DTASubWoofer"*²DTA Subwoofer"POSI"Position Setting"Preset"Preset value storage/recalling• "Preset": You can store an adjusted sound controlvalue by selecting "Memory". Refer to (page 16). Also, youcan recall it by selecting "Recall". Refer to (page 16).• You can adjust "SubWoofer" when Output> (page 12) is set to "SUBWOOFER ON".• X'Over (Crossover Network Setup)You can manually set a crossover frequency for thespeakers.• DTA (Digital Time Alignment)Manually set the sound output timing of eachchannel.• *1You can control this item when Speaker Select Rearof (page 13) is set toany item other than "None".• *2You can control this item when Speaker SelectSubwoofer of (page13) is set to any item other than "None".5Adjust the Sound Field Control itemPush the Control knob towards [4] or[¢].Each time you push the knob, the settingalternates between the settings shown in thetable below.Sound Field Control ItemRangeFront High Pass Filter Frequency/Rear High Pass Filter FrequencyThrough/30 — 100/120/150/180/220/250 (Hz)Front High Pass Filter Slope/Rear High Pass Filter Slope/Subwoofer Low Pass Filter Slope-12/-18/-24 dB/OctSubwoofer Low Pass Filter Frequency30 — 100/120/150/180/220/250 (Hz)/ThroughSubwoofer Low Pass Filter PhaseNormal/ Reverse
