Kenwood KDC-X990 Instruction Manual

Contents

16 | EnglishGeneral featuresBypass ControlTemorarily bypassing DSP (Digital SignalProcessor) System.1 Select the source to adjustPress the [SRC] button.2 Show the Multi-function displayPress the [NEXT] button repeatedly until"DSP" appears.Refer to (page9).3 Enter Bypass Control modeTurn the [VOL] knob to select "DSP".Press the [VOL] knob.• When "2ZONE" of

cannot select "DSP".4 Set up BypassPress the [VOL] knob."Bypass": There is no effect by DSP."Through": There is an effect by DSP.• When the mode is set to "Bypass", DSP System cannotbe adjusted.• When the mode is set to "Bypass", ODD D/A System isnot effective.Memory modeStoring the values of Sound Control in memory.1 Setup Sound ControlRefer to the following operations to setup theSound Control.-

- (page 12)- (page 13)- (page 14)2 Select the Preset Memory itemTurn the [VOL] knob to select "Preset".Press the [VOL] knob.3 Enter Memory modeTurn the [VOL] knob to select "Memory".Press the [VOL] knob.4 Put in the memoryTurn the [VOL] knob to select "Memory1" or"Memory2".Press the [VOL] knob for at least 2 seconds.The "MEMORY" display blinks 1 time.5 Exit Memory modeTurn the [VOL] knob to select "Return".Press the [VOL] knob.• "Memory1": When you press the Reset button, all thesources will be the setting value which isregistered.• The following items cannot be registered:Rear Volume, Balance, Fader, Position Setting, SystemQ SettingMemory Recall modeRecall the value in the memory by the memorymode.1 Select the source to adjustPress the [SRC] button.2 Show the Multi-function displayPress the [NEXT] button repeatedly until"S.F.C" appears.Refer to (page9).3 Select the key function which contains theitem you wish to recallTurn the [VOL] knob to select "S.F.C"/ "S.M.S"/"EQ".Press the [VOL] knob.4 Select the Preset Memory itemTurn the [VOL] knob to select "Preset".Press the [VOL] knob.5 Enter recall modeTurn the [VOL] knob to select "Recall".Press the [VOL] knob.6 Select the recall itemTurn the [VOL] knob to select "Recall1" or"Recall2".Press the [VOL] knob for at least 2 seconds.The "RECALL" display blinks 1 time.