48 | KDC-X994/ KDC-BT945U/ KDC-X794/ KDC-MP745UBluetooth SetupBluetooth SettingYou can select following Bluetooth Setting items.1 Enter Bluetooth modeKDC-X994 KDC-BT945UPress the [ ] button.KDC-X794 KDC-MP745UPress the [PLAY MODE] button for at least 1second.✍ You can also select from “Settings” in Menu Listmode.2 Turn the [VOL] knob and press it when thedesired item is displayed.Select “BT Settings”.3 Select the Menu itemTurn the [VOL] knob and press it when thedesired item is displayed.Display Overview“BT Settings”“Phone Selection” Select a cell-phone or Bluetooth audio playerconnection.Refer to Wish to Connect> (page 50).“Audio Selection”“SMS Download” Download a short message.Refer to (page 54).“SMS Inbox” Display the received short message.Refer to (page 54).“Voice Tag” Registers voice for voice recognition and voiceto select the Phone number category in Phonebook.- Adding a Voice Dialing Command (page 52)- Setting a Voice Command for Category (page52)“Detailed Setup” Move to detailed item.“Device Regist.” Register a Bluetooth device (pairing).Refer to (page 49).“SPCL DVCSelect”“Device Delete” Cancel registration of the Bluetooth device.Refer to device> (page 51).“PIN Code Edit” Specify the PIN code required when registeringthis unit using the Bluetooth device.Refer to (page 50).“Auto Answer” Answer a call automatically after lapse of thepreset time interval for automatic answer.“OFF”/ “0s” – “8s” – “99s”“Bluetooth HF/Audio”You can specify output speakers for hands-freevoice communication and Bluetooth audiosound.“FRONT”: Outputs voice from the frontspeakers.“ALL”: Outputs voice from the front and rearspeakers.“Call Beep” You can output a beep from the speaker whena call comes in.“ON”: Beep is heard.“OFF”: Beep is canceled.“BT F/W Update” Display the version of the firmware of this unit.“Mic Gain”* 1 Adjust the sensitivity of the microphone for atelephone call. Adjust the voice of caller. Settingto “+” increases the voice volume.“–3” – “0” – “+3”“NR Level”* 1 Reduce the noises generated by surroundingenvironment without changing the microphonevolume. Adjust the voice of caller when it isnot clear. Setting to “+” increases the noisereduction.“–3” – “0” – “+3”“Echo CancelLV“* 1Adjust the level of echo cancellation. Setting to“+” increases the echo cancel reduction.“–2” – “0” – “+2”( : Factory setting)*1 Function of KDC-X994/ KDC-BT945U4 Make a setting• When the “ PUSH ” icon is displayed (at theright edge of the display)Turn the [VOL] knob to select a setting value,and then press the [VOL] knob.• When the “ PUSH ” icon is not displayedPress the [4] or [¢] button to select asetting value.5 Exit BT Settings modeKDC-X994 KDC-BT945UPress the [ ] button.KDC-X794 KDC-MP745UPress the [PLAY MODE] button for at least 1second.Remarks• “Auto Answer” (Setting the Time Interval for AutomaticAnswer)This function automatically answers (responds to) a callafter lapse of the preset time interval for automatic answer.“OFF” : Does not answer the phone call automatically.“0” : Automatically answers the phone call at once.Function of KDC-X994/ KDC-BT945UKDC-X794/ KDC-MP745U with KCA-BT200 (Optional Accessory)4MENU VOL¢38 /PLAY MODE
