Kenwood KDV-5234 Instruction Manual

Also see for KDV-5234: Instruction manual

Contents

English 65General? The power does not turn ON.✔ The fuse has blown.After checking for short circuits in the wires,replace the fuse with one with the samerating.✔ The speaker wire has a short-circuit ortouches the chassis of the vehicle, and thenthe protection function is activated.Wire or insulate the speaker cable properlyand press the reset button.✔ A security code has been set.Enter the set security code (page 53).? No sound can be heard, or the volume is low.✔ The fader or balance settings are set all theway to one side.Center the fader and balance settings.✔ The "AMP" feature in Menu setup is "OFF".Turn the "AMP" feature "ON", referring to section (page 50).✔ The values for Volume offset are too low.Turn up the Volume offset, referring to the

✔ The input/output wires or wiring harness areconnected incorrectly.Reconnect the input/output wires orthe wiring harness correctly. Refer to the section (page 76).? The sound quality is poor or distorted.✔ One of the speaker wires is being pinchedby a screw in the car.Check the speaker wiring.✔ The speakers are not wired correctly.Reconnect the speaker wires so that eachoutput terminal is connected to a differentspeaker.? The TEL mute function does not work.✔ The TEL mute wire is not connectedproperly.Connect the wire correctly, referring to the section (page 76).? The TEL mute function turns ON eventhough the TEL mute wire is not connected.✔ The TEL mute wire is touching a metal partof the car.Pull the TEL mute wire away from the metalpart of the car.? The memory is erased when the ignition isturned OFF.✔ The ignition and battery wire are incorrectlyconnected.Connect the wire correctly, referring to the section (page 76).? There is no loudness effect.✔ You are using Subwoofer preout.Loudness has no effect in Subwoofer preout.? Even if Loudness is turned ON, high-pitchedtone is not compensated for.✔ Tuner source is selected.High-pitched tone isn’t compensated forwhen in Tuner source.? Radio reception is poor.✔ The car antenna is not extended.Pull the antenna out all the way.✔ The antenna control wire is not connected.Connect the wire correctly, referring to the section (page 76).? There is a source you cannot switch.✔ The Disc changer is not connected.Connect the Disc changer. If the Discchanger is not connected to it’s inputterminal, you cannot switch to an externaldisc source.? The display blacks out while scrolling.✔ The "DISP" feature under is"OFF".Turn the "DISP" feature "ON", referring to the section (page 50).Help? TroubleshootingHelp?