18 | Quick Start GuideInstallation/Removing the UnitNon-Japanese carsBend the tabs of the mounting sleevewith a screwdriver or similar tool andattach it in place.⁄• Make sure that the unit is installedsecurely in place. If the unit is unstable, itmay malfunction (for example, the soundmay skip).Japanese cars1. Refer to the section rubber frame> and then remove thehard rubber frame.2. Align the holes in the unit (two locationson each side) with the vehicle mountingbracket and secure the unit with theaccessory screws.8 mmMAX.ø5mm ø5mm8mmMAX.TN TNT/NT: Toyota carsN: Nissan carsAccessory 5...for Nissan carAccessory 6...for Toyota car5 6Removing the hard rubber frame1. Engage the catch pins on the removaltool and remove the two locks on theupper level.Lift up and pull the frame forward asshown in the figure.CatchLockRemoval tool (Accessory 2)2. When the upper level is removed,remove the lower two locations.⁄• The frame can be removed from thebottom side in the same manner.Removing the Unit1. Refer to the section rubber frame> and then remove thehard rubber frame.2. Insert the two removal tools deeply intothe slots on each side, as shown.3. Lower the removal tool toward thebottom, and pull out the unit halfwaywhile pressing towards the inside.Accessory 2¤• Be careful to avoid injury from the catchpins on the removal tool.4. Pull the unit all the way out with yourhands, being careful not to drop it.
