This function allows you to adjust the setting that is recalledwith the System Q, according to types of speakers.Press the SRC button repeatedly to select the standby mode."ALL OFF" is displayed when the standby mode is selected.Press the AUD button to enter the speaker setting mode.Press either the 4 or ¢ button to select the type ofspeaker. The setting switches as follows.Off ("SP OFF") / For the OEM speaker ("SP OEM") / For 6/6x9in. speaker ("SP 6/6x9inch") / For 5/4 in. speaker ("SP 5/4inch")Press the AUD button to end the speaker setting mode.Speaker setting function allows for tuning of bass, middle andtrebleNOTE4321Speaker SettingThe System Q function changes the values of the followingsound quality parameters:Bass centre frequency, bass level, bass quality factor, bassextend, middle centre frequency, middle level, middle qualityfactor, treble centre frequency, and treble level.Their setting values are different depending on the setting of thespeaker setting mode.NOTE"SYS-Q" : < System Q > Recalling the kenwood preset soundsettingPress the preset buttons (#1-6).Settings: #1;Flat (‘SYS-Q Flat”), #2;Rock (‘SYS-Q Rock”),#3;Top40 (‘SYS-Q Top40”), #4;Pops (‘SYS-Q Pops”),#5;Jazz (‘SYS-Q Jazz”), #6;Easy (‘SYS-Q Easy”)"V OFFSET" : Set the sound level of the each source selected byadjusting the level difference between the basicsound level and the required level.Setting values: - 8 – ± 0"Fader" : Adjust the fader level.Setting values: Rear 15 – Front 15"Balance" : Adjust the balance level.Setting values: Left 15 – Right 15"Treble" : Adjust the treble level.Setting values: - 8 – + 8"Bass" : Adjust the bass level.Setting values: - 8 – + 8— 7 —"Mid" : Adjust the middle level.Setting values: - 8 – + 8Please refer to the following for the adjusting values.Press the AUD button to end the control mode.4