Kenwood KR-A5040 Instruction Manual

Also see for KR-A5040: Instruction manual Instruction manual Service manual

Listening to broadcastsPOWER keyKENWOOD AM-FM STEREO RECEIVER KR-ASOSONumeric keysInput selector keys@ To listen to radio broadcasts1. Press the POWER key to ON.2. Prass the TUNER input selector key.3. Press the BAND selector key to select FM1, FM2 or AM.@ Every time the BAND selector key is pressed, the receiv-ing band is switched in order:[’ FM1 —4- FM2 +> AM 7BAND selector key VOLUME CONTROL knobAUTO keyVOLUME SONTROLafd ‘Bim ,.TUNING key4. Tune in the desired broadcasting station according to theinstructions in the’’Tuning methods‘‘section below.® During tuning, sound is not heard because the mutingcircuit is activated. The sound will be heard suddenly assoon as a station is received, so be careful in setting thesound volume level.5. When the desired station is received, adjust the volumewith the VOLUME CONTROL knob.a@ Tuning methodsAuto tuningWhen the TUNING key is pressed, broadcast frequencies arescanned automatically in the upward or downward directionunti! a station is located and tuned in. The stereo/monaural FMreception mode is set automatically according to the station.1. Press the AUTO key so that the AUTO indicator lights.2. Press the ~ (UP) or V {DOWN} segment of the TUNINGkey.®@ Press the “ (UP) segment scans broadcast frequenciesby varying the displayed frequencies in the upward direc-tion, and pressing the v (DOWN) segment scans byvarying the frequencies in the downward direction.@ When a broadcasting station is received, the frequencydisplay freezes and indicates the frequency of thereceived station.3. If the received station is not the desired station, pressthe same segment of the TUNING key again.@ Repeat this unit ihe desired station is received.JQ xR-45040 (En)Manual tuningStations with weak signal strength cannot be received by autotuning. In such cases, tune in the desired station by manualtuning. The station will be received in monaural mode(monaural mode is resistant to noise}. —1. Press the AUTO key so that the AUTO indicator is off.2. Press the “ (UP) or V (DOWN) segment of the TUNINGkey.@ Every time the TUNING key is pressed, the displayed fre-quency varies by one step in the direction indicated bythe pressed segment.@ Holding the TUNING key depressed varies the displayedfrequency continuously.3. When the frequency of the desired station is tuned in,release the TUNING key.@ Noise may be heard if the tuned frequency is not pre-cisely the same as the frequency of the station. In suchcases, press the “ (UP) or Y (DOWN) segment of theTUNING key to adjust the tuning precisely.