Kenwood KR-A5040 Instruction Manual

Also see for KR-A5040: Instruction manual Instruction manual Service manual

In case of difficultylf your unit should not perform as expected, consult the table below to see if the problem can be corrected before seekinghelp from your dealer or service representative.Symptom CausaNo power, no sound.No sound from left and right.Sound from left or right, but not both.Power cord not plugged in.Poor connection at wall outlet. PowerOuilet inactive.Speaker cords disconnected.Speakers switched off.® Poor speaker connections.Defective speaker.FM broadcast too noisy. Sufficientreception is impossible. ae deDubbing from TAPE 2 to TAPE 1 isimpossible.No sound is heard with both of theSPEAKERS A and B switches set toON.Remote control does not function.Occurs during AM reception onlyHigh-frequency whistle especially atOccurs during FM reception onlyHiss that gets worse in stereoreception.Indoor antenna is used.Poor connection of the antenna cable.The Input Selector TAPE 1 key ispressed.(The TAPE 1 indicator lights in thedisplay.}A pair of speakers Is not connected toone of the A or B speaker terminals.Batteries are not loaded. Or batteriesare exhausted.The remote sensor is obstructed.CauseCheck plug contact.Check outlet using a lamp or other ap-pliance (outlet may be conirolled by awall switch}. 'Check speaker connections.Check speaker switch.Interference from TV set.Check connections at both ends of.speaker cord.Reverse speakers, if prcblem stays withspeaker, have speaker checked.Use an outdoor antenna.Connect the antenna cable correctly.® Switch the input selector to a sourceother than TAPE 1.Connect two pairs of speakers correctlyto both A and B speaker terminals. Or,swiich the Speaker Selector to the A orB position to which the speakers areconnected.Replace the batteries with new ones.Remove the obstacle from in front ofthe remote sensor.try relocating TV set.Lighting. ;Fluorescent lamps starting.Appliance or furnace starting.GauseNo remedy.Try reversing AC plug.Try reversing AC plug.RemedyVery weak antenna input signal.Phythmic static or popping noises. Automobile ignition noise, especiallyevident when receiving weak signals.STEREO indicator fails to light duringstereo broadcast.Notes:Another possible effect of a very weaksignal.Consider an outdoor antenna installa-tion. In areas remote from the transmit-ter, a5 to 8 element antenna designedexclusively for FM is suggested.Review antenna installation. Site the an-tenna as far from the street as possibleand use coaxial cable.Antenna system needs attention (Seeabove).® As this system uses microcomputers, it ls open to interference from external noise, and may sometimes not function properly. In sucha case, unplug the power cord once, and then plug it in again.® Do not use contact cleaner because it could cause a malfunction. Be specially careful against contact cleaners containing oil, for theymay deform the plastic components.For the U.S.A.FCC WARNING:This equipment may generate or use radio frequency energy. Changes or modifications to this equioment may cause harmful!interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to oper-ate this equipment if an unauthorized change or modifictions is made.KR-A5040 (En) 19

/ 20

Related manuals for Kenwood KR-A5040