Kenwood KRC-278RA Instruction Manual

Also see for KRC-178RA: Service manual

cancelled.If you make no entry in a 10-second period, the name will bestored with the characters input so far.• The number of characters and discs whose names can bestored will differ depending on the disc changer that isconnected. Please see your disc changer manual for details.• Discs are identified by their total length and number of tracks. Ifanother disc happens to have the same specifications as onethat you have already stored a name for, the name will bedisplayed for it, too.• If you want to change the name of a disc, repeat steps 1 and 2to display the name, and then repeat steps 3 and 4 to input thechanges.• Pressing the reset button does not erase the disc names storedin a disc changer.NOTEStore the names of discs to be displayed when played.Play the disc whose name you want to preset.• This function is not available for disc changers that do notfeature the Disc Name Preset function.• This procedure is not to be used to store the disc and track titlesfor MDs that you record.Hold down the NAME.S button for two seconds or more."NAME SET" is displayed and the disc name preset mode isentered.The cursor blinks in the position where character input can bemade.Press either the 4 or ¢ button to move the cursor to thedesired position.The 4 button moves the cursor to the left, and the ¢button to the right.Press the DISC + or DISC – button to display the desiredcharacter.Characters that can be displayed are as follows.Alphabet (upper case) : A ~ ZNumerals and symbols : 0~9 @ " ‘ ` % & * + - = , . / \ < > [ ]The operation and characters that can be entered may changeas listed below, depending on the unit that is connected.Operations can be followed again from Step 2 at a time suchas this, and the characters to be input are selected using theprocedure described below.Press the DISC + or DISC – button to display the desiredcharacter. Besides the alphabet (capital letters only) andnumbers, you can choose the following characters: /, + , – , *,=, <, >, [ and ].Continue steps 3 and 4 until all the characters are chosen forthe name.Press the NAME.S button.The disc name is stored and the disc name preset mode is65NOTE432NOTE1Presetting Disc Names— 19 —