set the time manually if the automatic time adjustment functionis turned off. The factory default is automatic time adjustment.Display and setting:"SYNC ON" : Automatic time adjustment"SYNC OFF" : Manual time adjustmentAdjusting Time Automatically:Tune into an RDS station for 3 or 4 minutes.The time adjusts automatically to the correct local time.The time is not adjusted when the RDS station you are tuned to isnot transmitting a time signal. Choose another RDS station insuch a case.NOTEWith automatic time adjustment, you can set the clock timeautomatically according to time data sent from RDS stations(after receiving RDS signals for several minutes). You can alsoAutomatic Time AdjustmentAdjust the time manually.This adjustment is available only when the automatic timeadjustment is set to off.Display and setting:Select the display "CLK ADJ" during the selecting function inthe menu system.Hold down either the 4 or ¢ button for two seconds ormore to enter the Manual time adjustment mode.The time display will blink.• Adjusting the hoursPress the FM button to advance the hours, or press the AMbutton to make the hours go back.• Adjusting the minutesPress the ¢ button to advance the minutes, or press the4 button to make the minutes go back.321NOTEManual Time AdjustmentThis function produces a beep sound that accompanies buttonoperation. It can be switched on or off.Display and setting:"BEEP ON" : Beep setting is on."BEEP OFF" : Beep setting is off.The beep sound is not output from the preout jacks.NOTETouch Sensor Tone— 21 —