Function of the KRC-608This function allows you to adjust the setting that is recalledwith the sound coordinate system, according to types ofspeakers.Press the SRC button repeatedly to select the standby mode."ALL OFF" is displayed when the standby mode is selected.Press the AUD button to enter the mobile preset plan mode.Press either the 4 or ¢ button to select the type ofspeaker. The setting switches as follows.Off / For the OEM speaker / For 6/6x9 in. speaker /For 5/4 in. speakerPress the AUD button to end the mobile preset plan mode.• This mode is available only when the Sound coordinate systemis on. (page 25)• When you change the setting of type of speaker, the bass andtreble tone settings are returned to original levels.NOTE4321Mobile Preset"V OFFSET/VOS" : Set the sound level of the each sourceselected by adjusting the level differencebetween the basic sound level and therequired level.Setting values: - 8 – ± 0“Fader/FAD” : Adjust the fader level.Setting values: Front 15 – Rear 15“Balance/BAL” : Adjust the balance level.Setting values: Left 15 – Right 15“Treble/TRE” : Adjust the treble level.Setting values: - 8 – + 8“Bass/BAS” : Adjust the bass level.Setting values: - 8 – + 8— 7 —"ec4/EC4" : Recalling the kenwood preset sound settingPress the preset buttons (#1-6).Settings: #1;Flat, #2;Rock, #3;Pops/Top40, #4;Jazz, #5;Easy,#6;Scan of #1-5 (KRC-608 only)• This mode is available only when the Sound coordinate systemis on. (page 25)• You can call the following settings with this function; basscenter frequency, bass level, bass quality factor, bass extension,treble center frequency, and treble level setting. Their settingvalues are different depending on the setting of the mobilepreset plan mode.NOTE