— 31 —ANT CONTILLUMIP.CONT.++++FRONT • LFRONT • RREAR • LREAR • R–+REAR FRONTRLConnecting Wires to TerminalsWhen only two speakers are being connected to thesystem, connect the connectors either to both thefront output terminals or to both the rear outputterminals (do not mix front and rear). For example, ifyou connect the + connector of the left speaker to afront output terminal, do not connect the - connectorto a rear output terminal.2CAUTIONIf you connect the ignition wire (red) and the batterywire (yellow) to the car chassis (ground), you maycause a short circuit, that in turn may start a fire.Always connect those wires to the power sourcerunning through the fuse box.2WARNINGFM/AM antenna inputRear left output (White)Rear right output (Red) Fuse (10A)Wiring harness(Accessory1)White/BlackGray/BlackGreen/BlackPurple/BlackWhiteGrayGreenPurpleTo front leftspeakerTo front rightspeakerTo rear rightspeakerTo rear leftspeakerIgnition wire (Red)Battery wire (Yellow)Ground wire (Black) - (To car chassis)Ignition keyswitchCar fusebox(Main fuse)ACCCar fuse boxBatteryIf no connections are made, do not let the wire come out from the tab.Front left output (White)Front right output (Red)Power control wire (Blue/White)Motor antenna control wire (Blue)Dimmer control wire (Orange / White)When using the optional power amplifier, connectto its power control terminal.To car light control switchDepending on what antenna you are using, connecteither to the control terminal of the motor antenna, orto the power terminal for the booster amplifier of thefilm-type antenna.To KENWOOD disc changer/DAB control input/KPA-SD100/KPA-HD100/KPA-SS100To connect these leads, refer to therelevant instruction manuals.NOTE