English— 32 —Make sure that the unit is installed securely in place. If the unitis unstable, it may malfunction (for example, the sound mayskip).NOTEBend the tabs of themounting sleeve witha screwdriver or similarutensil and attach it inplace.Accessory2Metal mountingstrapPhillips trusshead sheetmetal screw(commerciallyavailable)Firewall or metal supportAccessory4Installation (non-Japanese cars)Installation (non-Japanese cars)To attach this unit, make sure the front of the control panel facesyou and fit it into the mounting sleeve by pressing the four cornersof the hard rubber frame at the same time.Do not apply strong pressure to other sections than the corners;otherwise troubles such as the impossibility of opening or closingthe panel may result.2CAUTIONRefer to the section "Removing the faceplate (page 10)" andthen reattaching the faceplate.Never insert the taptite screws (ø2 × 4 mm) in any other screwholes than the one specified. If you insert it in another hole, itwill contract and may cause damage to the mechanical partsinside the unit.2CAUTION3Locking the faceplate to the unitIf you want to lock the faceplate to the unit so that it does notfall off, follow the directions below.Refer to the function "Removing the faceplate (page 10)" andremove the faceplate.Insert the provided screw into the hole at the center of thebottom side of the faceplate which you have removed fromthe unit.21Accessory7Locking the faceplate to the unit