Kenwood KRC-PS978R Instruction Manual

You can adjust the faceplate angle for easy viewing.Adjusting faceplate angle:Press the ¡ (EJECT) button to make the faceplate slide open,and then adjust the faceplate angle using the angle adjustmentswitch.Adjustment may be made from 0 to 2.• Firmly slide the switch until it clicks.• Do not apply excessive force to the faceplate under settings 1or 2.• Set the angle adjustment switch to "0" before removing thefaceplate.NOTE0 1 20 1 2021Faceplate Angle AdjustmentThis function prevents tampering with the unit your car isbeing serviced etc.Hiding the unit with the ignition turned on (forced closing):Hold down the SRC button for one second or more.The faceplate will slide open. When the period of time whichyou have set in the "Time setting for removing the faceplate" inthe menu has passed, the faceplate automatically reverses tohide the control panel. However, you can remove the faceplateduring that period. For details, refer to the "Removing thefaceplate" (page10).• When the closing faceplate is hit by an object, the unit will turnoff without the faceplate closing all the way. Remove the objectand press the SRC button to turn the unit back on, then turn itoff again to make it close properly.• Whilst the control panel is moving, pressing the buttons will nothave any effect. Do not try to press the buttons on the controlpanel as the faceplate is moving, as excessive force maydamage the unit.• During the forced closing of the unit (i.e., having the unit leftclosed whilst ignition is turned on), the faceplate will not openno matter how often the ignition is turned on or off, unless"Manual Open button" at the rear of the faceplate is pressed inorder to open it. You can prevent tampering of the unit whenletting someone else drive your car by keeping it closed thisway.To cancel the forced closing of unit and open control panel:Press the left part at the upper side of the faceplate for asmany times as you have preset in the "Manual Open ButtonSetting" (OPEN SW #) in the menu. The faceplate will open andshow the control panel.When you set the Manual Open Button setting to 2 or 3, pressthe upper left part of the faceplate without pausing. If you do notpress that part without pausing, the command cannot be verifiedcorrectly.NOTENOTEForced ClosingGeneral features— 8 —English