12PreparationsKRF-V7010/V6010/V5010 (En/T)Speaker placementSubwooferFront speakers : Place to the front left and right of the listeningposition. Front speakers are required for all surround modes.Center speaker : Place front and center. This speaker stabilizes thesound image and helps recreate sound motion. Be sure to connecta center speaker when using the Dolby 3 Stereo mode.Surround speakers : Place to the direct left and right, or slightlybehind, the listening position at even heights, approximately 1 meterabove the ears of the listeners. These speakers recreate soundmotion and atmosphere. Required for surround playback.Subwoofer : Reproduces powerful deep bass sounds.FrontspeakerCenter speakerListeningpositionSurroundspeaker• Although the ideal surround system consists of all the speakerslisted above, if you don't have a center speaker or a subwoofer, youcan divide those signals between the available speakers in thespeaker settings to obtain the best possible surround reproductionfrom the speakers you have available. #Setting up the systemLoading the batteriesPreparing the remote control (RC-R0507)• Insert four AAA-size (LR03) batteries as indicated by the polaritymarkings.3 Close the cover.2 Insert the batteries.1 Remove the cover.Notes1. The supplied batteries may have shorter lives than ordinary batteriesdue to use during operation checks.2. Replace all four batteries with new ones when you notice a shorteningof the distance from which the remote control will operate or if theremote control blinks 5 times when you press a key. The remote controlis designed to retain set up codes in memory while you changebatteries.3. Placing the remote sensor in direct sunlight, or in direct light from ahigh frequency fluorescent lamp may cause a malfunction.In such a case, change the location of the system installation toprevent malfunction.Remote sensorModel: RC-R0507Infrared ray system6 m10 m30˚ 30˚• When pressing more than one remote control key successively,press the keys securely by leaving an interval of 1 second or morebetween keys.OperationWhen the STANDBY indicator is lit, the power turns ON when you pressthe POWER key on the remote control. When the power comes ON,press the key you want to operate.Operating range(Approx.)