Kenwood KRF-V6060D Instruction Manual

Also see for KRF-V6060D: Instruction manual Service manual Service manual

21 ENListening to a source componentVOLUME CONTROLVOLUME /INPUT SELECTORInput Selector AV AUX1Use the Input Selector and AV AUX keys to select thesource you want to listen to.Selecting a source using each key.VR-6050/KRF-V7060D/V6060D1 “DVD/6CH”2 “CD/DVD”3 “AUX” or “PHONO” (for KRF-V7060D only)4 “TUNER”5 “VIDEO 1”6 “VIDEO 2”7 “VIDEO 3”8 “MD/TAPE”9 “AV AUX”KRF-V6060D (for the U.K. only)1 “DVD/6CH”2 “CD/DVD”3 “PHONO”4 “TUNER”5 “VIDEO 1”6 “VIDEO 2”7 “VIDEO 3”8 “MD/TAPE”9 “AV AUX”2Start playback from the selected source.3Use the VOLUME CONTROL knob or VOLUME +/-keys toadjust the volume.Normal playbackPreparing for playbackSome preparatory steps are needed before starting playback.INPUT MODEMD/TAPEPOWER ON/OFF(KRF-V7060D/V6060D)A SPEAKERS BPOWERON/STANDBY(VR-6050)ON/STANDBY(KRF-V7060D/V6060D)Turning on the receiver1 Turn on the power to the related components.2 Turn on the power to this receiver by pressing the POWERON/STANDBY (for VR-6050) key or POWER ON/OFF andON/STANDBY (for KRF-V7060D/V6060D) key.Selecting the input modeIf you have selected a component connected to the CD/DVD, VIDEO 2or DVD/6CH jacks, make sure that the input mode setting is correct forthe type of audio signal to be used. 9Selecting MD/TAPESelect the source name corresponding to the component connected tothe MD/TAPE jacks. The initial factory setting is “TAPE”. To change thesource to “MD”, follow the steps below:Hold down the MD/TAPE key for more than 2 seconds.• The source indication changes to “MD”.• To return to the original indication, repeat the above procedure.Selecting the speaker systemPress the A SPEAKERS B key to select the speaker system to beused.A ON : Sound from the speakers connected to the SPEAKERS Aterminals on the rear panel.B ON : Sound from the speakers connected to the SPEAKERS Bterminals on the rear panel. No sound will be heard fromthe subwoofer.A+B ON : Sound from both the speakers connected to theSPEAKERS A and B terminals on the rear panel.A+B OFF : No sound from the speakers. Use this setting whenlistening with headphones for stereo sound in all playbackmodes. The display segments are different depending onthe type of input signal.The indicator for the speakersyou want to use should be lit.LSL S SB SRC RSP MUTE OPTICAL 6CH INPUTCOAXIAL ANALOG 96kHzfsCINEMACTIVDSP MA B CLIPAUTO DETECTSWLFE• Selecting “6CH INPUT” by pressing the INPUT MODE key, whereby“DVD/6CH” is the input source will cause SPEAKERS A to be selectedautomatically.