93TroubleshootingSoundI can’t hear sound from one or more of the speakers, or the soundis abnormally lowCheck that:• All of the speaker wires are connected tightly, not short circuited. SeeChapter One of the Connections and Setup Guide.The 96k fs indicator does not light while a 96k fs compatible disc is beingplayed.• The indicator will not light unless the DVD player is properly set.• All of the speakers have been activated in the Setup Speakers menu.See Chapter Two of the Connections and Setup Guide.• The individual speaker levels are set properly. See Chapter Two of theConnections and Setup Guide.• The CD2/TAPE2 MONITOR input has not been selected. (If it has,the CD2/TAPE2 MONITOR indicator on the receiver’s front panelwill be lit). See “What’s on the Front Panel of Your Kenwood Audio -Video Receiver?” on page␣ 2 of this manual.• The correct speakers have been activated. See “Turning the SpeakersOn” on page␣ 10 of this manual.• The correct listen mode has been selected. See “What Are ListenModes?” on page 17 of this manual.I can’t hear sound from my surround or center speakersCheck that:• The proper surround play mode (Dolby 3 Stereo, Dolby Pro Logic,DSP, MPEG, DTS or Dolby Digital) has been selected. See “What areListen Modes?” on page␣ 17 of this manual.• All of the speaker wires are connected tightly. See Chapter One of theConnections and Setup Guide.I can hear sound only from the center speaker when Dolby ProLogic or Dolby 3 Stereo is selectedCheck that the program (e.g., TV show, radio station, VCR tape) is instereo. Programs in mono play only through the center speaker when thereceiver is in the Dolby Pro Logic listen mode.