Using Receiver61How Do I Record (Edit Mode)?• If you’re recording from a digital source, any action other than adjust-ing the volume may cause the sound to “clip” on the recording.• You cannot record from the component you are using to record. Forexample, if you’re recording on a VCR connected to the VIDEO1 jacks,select a source other than Video 1.• If your source is a camcorder or other video unit, refer to the instruc-tion manual for the particular unit you’re recording from.• It is not possible to record a digital source signal onto the device con-nected to the CD2/TAPE2 MONITOR output.Digital to Digital Recording:The PCM digital signal input through any DIGITAL IN jack is output digi-tally at the digital jack. For more information on this connection, see“Connecting Your MD Recorder or Primary Tape Deck” on page␣ 20 ofthe Connections and Setup Guide.Dolby Digital and DTS signals cannot be recorded.Digital to Analog Recording:While home VCRs can record only two channels of audio, the receiver iscapable of "down-mixing" the multi-channel audio of Dolby Digital, DTSor MPEG into stereo sound. Down-mixing is available by setting the DigitalRec mode to “REC MODE: AUTO or “REC MODE: MANUAL”.To set the Digital Rec mode:1. Touch the (Src.) or (Det.) so that (Src.) is reversed.2. Select or .3. When or is selected, the receiver displays "REC MODE:AUTO" or "REC MODE: MANUAL".When a source recorded by down-mixing a multi-channel source is playedback in the Dolby Pro Logic mode, the audio can be reproduced in 4-channel surround sound.
