Kenwood M-707i Instruction Manual

Also see for M-707i: Instruction manual

Kenwood M-707i Instruction Manual Manual pdf 5 page image

English 5Preparing the remote control unitPull the battery sheet out from theremote control unit to the direction ofthe arrow.OperationWhen the power cord is plugged in, standbyindicator is lit. The power turns ON by pressingbutton on the remote control unit pointing at theremote sensor. When the power comes on, press thebutton you want to operate.SLEEPPTYTUNER bandRVS PLAYSEARCH / TUNINGP.CALL / ALBUM CLEARFWD PLAYTAPE mode iPodVOLUMEMUTECD / USBTIMERSET TIMERON / OFF TIMEDISPLAYRDSDISPLAYP.MODE ABC DEFGHI JKL MNOPQRS TUV WXYZINTROEQX-BASSRANDOMREPEATFILE SEARCHSTEREO/MONOUSB O.T.E TAPE RECREMOTE CONTROL UNITRC-F0713EENTERApprox. 6 m30°30°Remote sensor¤ CAUTION• Lithium battery.Danger of explosion if the battery is incorrectly replaced.Replace only with the same or equivalent type.• The battery pack or batteries shall not be exposed toexcessive heat such sunshine, fire or the like.• Keep battery out of reach of children and in originalpackage until ready to use. Dispose of used batteriespromptly. If swallowed contact physician immediately.⁄• The supplied battery may have shorter live than ordinarybattery due to use during operation checks.• When the remote-controllable distance gets shorter thanbefore, replace the battery with a new one.• Placing the remote sensor in direct sunlight, or in directlight from a high frequency fluorescent lamp may cause amalfunction.In such a case, change the location of the system installationto prevent malfunction.Changing the battery of the remote controlunitUse a commercially available button battery(CR2025).1 Insert something narrow like a paperclip intothe hole 1 and pull out the battery tray.Keep on slidePull out2 Replace the old battery with a new one.CR2025(+side)Description of the button name in thismanualMost of the functions are designed to be able tooperate from the remote control unit. Therefore, inthis manual, the button names are described usingthe names on the remote control unit first, followedby names on the main unit put in parenthesis.Example:X-BASS [X-bass] buttonButton on the main unitButton on the remote control unit