Kenwood NEXEDGE NX-200 Instruction Manual

Also see for NEXEDGE NX-200: Brochure Instruction manual Instruction manual Specifications Instruction manual

Contents

8• Select “ALL” Fleet and “ALL” ID to make a call to all units(Broadcast call).StAtuS meSSAgeYou can send and receive 2-digit Status messages which maybe decided in your talk group. Messages can contain up to alphanumeric characters. Status messages range from 0 to99 (80 ~ 99 are reserved for special messages).A maximum of received messages (combined statusmessages and short messages) can be stored in the stackmemory of your transceiver.■ Transmitting1 Select your desired zone and channel.2 Press the key programmed as Status to enter Statusmode (proceed to step ) or Selcall + Status to enterSelcall mode (proceed to step 3).3 Press / to select the station you want to call.• If Manual Dialing is enabled, you can enter a station IDby using the DTMF keypad, or by using / . Whenusing / , cycle through the digits to select a digit,then press to set the digit and move the cursor to theright. Repeat this process until the entire ID is entered.4 Press to enter Status mode.5 Press / to select the status you want to transmit.• If Manual Dialing is enabled, you can enter a status ID byusing the DTMF keypad, or by using / (refer tostep 3, above).6 Press the PTT switch or Side 2 key to initiate the call.• “” appears on the display when the statushas been successfully transmitted.