115 Press the / key to select the status you want to transmit.• If Manual Dialing is enabled, you can enter a station ID by using the microphoneDTMF keypad (refer to step 3, above).6 Press the PTT switch to initiate the call.• “COMPLETE” appears on the display when the status has been successfullytransmitted.■ ReceivingA calling ID or text message will appear when a Status call is received. Press any keyto return to normal operation.■ Reviewing Messages in the Stack Memory1 Press the key programmed as [Stack], or press and hold the key programmed as[Selcall], [Status], or [Selcall + Status] to enter Stack mode.• The last received message is displayed.2 Press the / key to select the desired message.• Message types are identified as follows:ID: Caller ID, ST: Status Message, ME: Short Message• Press and hold the S or key for 1 second to cycle the display information asfollows:ID Name > Status/Short Message > CH/GID3 Press the key to return to normal operation.• To delete the selected message, press the A or # key. To confirm the deletion,Press the S or key.• To delete all messages, press and hold the A or # key for 1 second. To confirmthe deletion, Press the S or key.SHORT MESSAGESThis transceiver can receive short data messages which contain a maximum of 48characters.• Received short messages are displayed the same as Status messages. A maximum of15 received messages (combined status messages and short messages) can be storedin the stack memory of your transceiver.GPS REPORTGPS data can be manually transmitted by pressing the key programmed as [Send theGPS data]. If set up by your dealer, GPS data may be automatically transmitted at apreset time interval.• When using the NX-720G/ NX-820G, you must connect a KRA-40 GPS antenna.• When using the NX-720/ NX-820, you must connect an external GPS unit.• When the power is turned ON and/or the reception condition of the GPS satellite ispoor, positioning completion time may take longer.