Kenwood NEXEDGE NX-820HG Instruction Manual

Also see for Nexedge NX-720H: Instruction manual Instruction manual Service manual

10FleetSync: ALPHANUMERIC 2-WAY PAGING FUNCTIONFleetSync is an Alphanumeric 2-way Paging Function, and is a protocol owned byJVC KENWOOD Corporation.Note: This function is available only in analog operation.SELCALL (SELECTIVE CALLING)A Selcall is a voice call to a station or group of stations.■ Transmitting1 Select your desired zone and channel.2 Press the key programmed as [Selcall] to enter Selcall mode.3 Press the / key to select the station you want to call.4 Press the PTT switch and begin your conversation.■ ReceivingAn alert tone will sound and the transceiver will enter Selcall mode. The calling station’sID will appear when a Selcall is received. You can respond to the call by pressing thePTT switch and speaking into the microphone.■ Identifi cation CodesAn ID code is a combination of a 3-digit Fleet number and a 4-digit ID number. Eachtransceiver has its own ID.• Enter a Fleet number (100 ~ 349) to make a group call.• Enter an ID number (1000 ~ 4999) to make an individual call in your fl eet.• Enter a Fleet number to make a call to all units in the selected fl eet (Fleet call).STATUS MESSAGEYou can send and receive 2-digit Status messages which may be decided in your talkgroup. Messages can contain up to 16 alphanumeric characters. Status messages rangefrom 10 to 99 (80 ~ 99 are reserved for special messages).A maximum of 15 received messages (combined status messages and short messages)can be stored in the stack memory of your transceiver.■ Transmitting1 Select your desired zone and channel.2 Press the key programmed as [Status] to enter Status mode (proceed to step 5) or[Selcall + Status] to enter Selcall mode (proceed to step 3).3 Press the / key to select the station you want to call.• If Manual Dialing is enabled, you can enter a station ID by using the microphoneDTMF keypad by pressing and holding the S or key. Repeat this processuntil the entire ID is entered.4 Press the S or key to enter Status mode.