Kenwood NEXEDGE NX-820HG Instruction Manual

Also see for Nexedge NX-720H: Instruction manual Instruction manual Service manual

12TRUNKING CALLS (ANALOG)PLACING A DISPATCH CALL1 Select the desired zone and channel/group ID.2 Press and hold the PTT switch.3 If the “PTT Proceed” tone sounds, communication is possible; start speaking into themicrophone. Release the PTT switch to receive.• For best sound quality at the receiving station, hold the microphone approximately1.5 inches (3 ~ 4 cm) from your mouth.• Your dealer can deactivate the Proceed PTT tone, if necessary. Ask your dealer fordetails.RECEIVING A DISPATCH CALL1 When a dispatch call is received, the transceiver will automatically change to thecorrect group ID and you will hear the call.2 Readjust the volume as necessary.PLACING A TELEPHONE CALL1 Select the desired zone and channel/group ID.2 Press and hold the PTT switch for approximately 1 second to ensure a connection.• Confi rm that there is a dial tone after releasing the PTT switch.3 Alternatively, press the key programmed as [Auto Telephone] to automatically searchfor a Telephone Repeater.• “AUTO TEL” appears on the display and the icon blinks.• When the transceiver connects to a telephone line, a dial tone sounds, the iconappears on the display, and the transceiver enters the Off Hook state.4 Place the call, following the instructions for making a DTMF call, starting on page 13.5 When the called party responds, press the PTT switch and speak into the microphone.Release the PTT switch to receive.• Only one person can speak at a time.RECEIVING A TELEPHONE CALL1 When a telephone call is received, the transceiver will automatically change to thecorrect group ID and you will hear the call.• A ringer tone will sound when a call is received.2 Press and hold the PTT switch to speak, and release it to receive.• Only one person can speak at a time.DISCONNECT WITH TELEPHONETo end the call, press the # key or the key programmed as [Telephone Disconnect] whilecommunicating.