Kenwood NX-1000 Series User Manual

Also see for NX-1000 Series: User manual User guide User manual User manual User manual

73Identification CodesAn ID code is a combination of a 3-digit Fleet number and a 4-digit ID number.Each transceiver has its own ID.• Enter a Fleet number (100 ~ 349) to make a fleet call.• Enter an ID number (1000 ~ 4999) to make an individual call in your fleet.• Enter a Group ID (which is programmed in the FPU) to make a group call.• Enter a Fleet number followed by an ID number to make an individual call inyour desired fleet (Inter-fleet call).• Select “ALL” Fleet and “ALL” ID to make a call to all units (Broadcast call).• Select “ALL” Fleet and enter an ID number to make a call to the selected ID inall fleets (Supervisor call).STATUS MESSAGEYou can send and receive 2-digit Status messages which may be decided inyour talk group. Messages can contain up to 8 alphanumeric characters. Statusmessages range from 10 to 99 (80 ~ 99 are reserved for special messages).A maximum of 32 received messages can be stored in the stack memory of yourtransceiver. These saved messages can be reviewed after reception. Dependingon your dealer settings, when the stack memory is full, either the oldest messagewill be erased when a new message is received or the new message will not bestored in the stack memory. The “ ” indicator appears when a message is storedin the stack memory.Transmitting1 Select your desired zone and channel.2 Press the button programmed as [Status] to enter Status Mode (proceed tostep 5), or [Individual + Status]/ [Group + Status] to enter Selcall Mode(proceed to step 3).3 Press the [ and [ C> ] buttons to select the station you want to call.4 Press the [ S ] button to enter Status Mode.5 Press the [ and [ C> ] buttons to select the status you want to transmit.6 Press the PTT switch or Side 2 button to send Status messages.• “COMPLETE” appears on the display when the status has beensuccessfully transmitted.ReceivingThe “ ” indicator will flash and a calling ID or text message will appear when aStatus call is received. Press any button to return to normal operation.