Kenwood NX-1200 Series Service Manual

Also see for NX-1200 Series: Function reference

(No.RA077)1-17(7) Remove PCB screws (x8).(8) Desolder the ANT Receptacle and Positive Terminal.(9) Unlock the FPC connector and remove FPC cable from it,then remove the PCB from Chassis.(10) Untighten the screws of ANT Receptacle and circular nutsof Variable Resistor (Volume) & Rotary Switch (Selector),then remove ANT Receptacle, spring washers, Volume,Selector from Chassis.(11) Remove Rubber Seal & Holder Assy, Packing fromChassis.(12) Remove the Battery Release Lever from the front case.• Press the upper part of the lever toward the inside of thefront case. One side of the shaft will be removed. <1>• Lift and remove the battery release lever from the frontcase. <2>Note:Scratch and widen the glue hole if there is difficulty inremoving the other end of the shaft.No glue is required when you reassemble the batteryrelease lever.DesolderANT ReceptacleDesolderPositive terminalLatchLift the latch to unlock the FPC connector.FPC connectorSpring WasherCircular NutVolumeSelectorANTReceptaclePackingRubber SealHolderAssy<1><2>Battery Release Lever