1-14 (No.RA003)3.2 Precautions for Reassembly3.2.1 Attaching the Battery Release Lever to the Case As-sembly(1) Insert one side of the shaft into the hole at the lever fittingsection on the case assembly <1>.Caution:Position the thin spring (G01-4543-14) above the twotabs of the lever.(2) Tilt the battery release lever slightly forward <2>, so thatthe thick spring (G01-4542-04) is positioned below thecase surface.(3) With the thick spring positioned below the case surface, at-tach the other side of the shaft to the case assembly bypressing the battery release lever <3> until it snaps intoplace <4>.Caution:Be careful to not tilt the battery release lever too far for-ward.If the battery release lever is pushed in this state wherethe two tabs come below the case surface, there is apossibility of damaging the two tabs.3.2.2 Assembling the Battery Release Lever(1) Place the lever <2> onto the stopper <1>.(2) Place the thick spring <3> onto the lever.(3) Hook the right and left ends of the thin spring <4> onto thetabs of the stopper, then place the thin spring onto the lever<5>.(4) Slide the shaft through the hole of the stopper and lever<6>.3.2.3 Attaching the Positive Terminal to the ChassisAlways attach the positive terminal to the chassis using the fol-lowing procedures, before mounting the TX-RX unit onto thechassis.(1) Remove the holder assembly <2> from the packing <1> ofthe positive terminal.(2) Mount the packing of the positive terminal into the chassishole <3>.(3) Mount the holder assembly into the packing of the positiveterminal <4>.A thin springShaftTow tabsA thick spring<1> <2><4><3><1><2><3><4><5><6><1><3><2> <4>
