(No.RA003)1-215.2 REALIGNMENT5.2.1 Modes5.2.2 How to Enter Each Mode5.2.3 PC Mode5.2.3.1 PrefaceThe transceiver is programmed by using a personal computer, aprogramming interface (KPG-22A/22U) and the FPU (program-ming software).The programming software can be used with a PC. Figure 1shows the setup of a PC for programming.Fig.15.2.3.2 Connection procedure(1) Connect the transceiver to the computer using the interfacecable.Note:You must install the KPG-22U driver in the computer touse the USB programming interface cable (KPG-22U).(2) When the Power is switched on, you can immediately enteruser mode. When the PC sends a command, the transceiv-er enters PC mode.When data is transmitting from the transceiver, the red LEDlights.When data is being received by the transceiver, the greenLED lights.Note:• The data stored in the computer must match the “Mod-el Name and Model Type” when it is written into theEEPROM.• Do not press the [PTT] key during data transmission orreception.Mode FunctionUser mode For normal use.PC mode Used to communication between thetransceiver and PC.Data programmingmodeUsed to read and write frequency data andother features to and from the transceiver.PC test mode Used to check the transceiver using thePC. This feature is included in the FPU.Wireless clonemodeUsed to transfer programming data fromone transceiver to another.Mode OperationUser mode Power ONPC mode Received commands from PCWireless clonemode[PTT] + [Side2] + Power ON (Two seconds)User modeData programming modePC test mode PC tuning modePC modeWireless clone modePCKPG-22A or KPG-22UFPUTuning cable(E30-3216-05)GrayGray/Black1.5D-XV Lead wire1.5D-XV Shield wire+–+–SPMICD-SUB(9-pin)KPG-22APCTransceiver TransceiverUSBKPG-22UPC
