1-36 (No.RA017)SECTION 4ADJUSTMENT4.1 F,F2,K,K2 TYPE Controls4.1.1 Preparations for checking/tuning the transceiverBefore attempting to check/tune the transceiver, connect the unitto a suitable power supply.Whenever the transmitter is turned on, the unit must be connect-ed to a suitable dummy load (i.e. power meter).The speaker output connector must be terminated with an 4Ωdummy load and connected to an AC voltmeter and an audio dis-tortion meter or a SINAD measurement meter at all times duringchecking/tuning.4.2 Panel Test Mode4.2.1 Test mode operation featuresThis transceiver has a test mode. To enter test mode, press andhold the [ ] key while turning the transceiver power ON. Beforethe transceiver enters test mode, the frequency version informa-tion appears on the LCD momentarily. Test mode can be inhibit-ed by programming. To exit test mode, turn the transceiverpower OFF. The following functions are available in test mode.• When the panel test mode is activated, the last used channeland signaling numbers are displayed. When the panel testmode is activated for the first time, the channel and signalingnumbers are 1.• If test signaling 10 (P25 Phase1), 7 (P25 Phase2) and 7(NXDN Mode) is selected, the result of Bit Error Rate (BER)calculation is displayed on the LCD.4.2.2 Key operation*1: When the mode is selected as Analog, this function is en-abled.*2: When the mode is selected as P25, bandwidth is fixed to Nar-row.Power switchChannel Up/Down keyVolume Up/Down keyMIC jack Auxiliary (orange) keyKMC-36 (OPTION)Keypad[PTT]Key "Func" not appears on the sub LCD displayFunction Display[+] Push: Volume upHold: Volume up continu-ously-[-] Push: Volume downHold: Volume down con-tinuously-[] Push: Test channel upHold: Test channel upcontinuouslyChannel No.[] Push: Test channel downHold: Test channel downcontinuouslyChannel No.[] Push: Squelch level up *1Hold: Squelch offSquelch levelSquelch off: iconappears[] Wide/Narrow/Very Narrow *2Wide : "w"Narrow: "n"Very Narrow: "v"[ ] Shift to panel tuningmode-[ ] Function on "Func" appears on thesub LCD display[ ] MSK 1200bps and2400bps *12400bps: iconappears[ ] Push: Test signaling upHold: Test signaling upcontinuouslySignaling No.[AUX(Orange)]- -[PTT] Transmit -[0] to [9]and[#], [ ]- -Key "Func" appears on the sub LCD displayFunction Display[+] P25 Modulation Type(C4FM/LSM) *3LSM : icon appears[-] Function off -[] Talk Around on/off On: icon appears[] Mode selectionAnalog/P25 Phase1/P25 Phase2/NXDNAnalog: "A"P25 Phase1: "P1"P25 Phase2: "P2"NXDN: "N"[] - -
