(No.RA017)1-5SECTION 2SPECIFIC SERVICE INSTRUCTIONS2.1 SYSTEM SET-UPMerchandise receivedChoose the type of transceiverTransceiver programming A personal computer, programming interface (KPG-46U/46X), andFPU (programming software) are required for programming.NX-5800 or NX-5800(B)?Are you usingthe ignition sense cable?Are you usingthe Multi-RF Deck/Multi-ControlAre you usingthe public address?KCT-46KAP-2NX-5800(B)NX-5800YESNONOYESNOSupplied microphoneDeliveryAre you usingthe external speaker?Are you usingthe keypad microphone?KES-3 or KES-5KMC-36YESNOYESNODesk top microphone KMC-9C/KMC-53(Option)(Option)(Option)(Option)Operation panel (KCH-19)KCT-23 DC cable KCT-23 M,M3Are you usingthe secure cryptographic module?NO(Option)YES KWD-AE30 or KWD-AE31Refer to the “2.3.2 Horn Alert/P.A.Relay Unit (KAP-2: Option)”.Refer to the “2.3.3 ExternalSpeaker (Option)”.Refer to the “2.3.1 Ignition SenseCable (KCT-46:Option)”.Refer to the “2.3.4 SECURE CRYPTOGRAPHICMODULE (KWD-AE30/KWD-AE31: Option)”.Head remote kit?Are you usingthe GPS function? KRA-40 GPS active antennaYESNO(Option)YESRefer to the KRK-14H/15B service manual(B5B-7173-10) for Setup and installationinformation for all combinations.(Also includes installation information forKCH-20R.)It's possible to combine and install theRF Deck (NX-5800), Remote Kit (KRK-14H,KRK-15B), Control Head (KCH-19, KCH-20R)and Cable (KCT-71, KCT-72) respectively.Frequency range (MHz) RF power Type380~470400~47045W45W45WNoNoYesNX-5800(B) K2NX-5800(B) F2NX-5800 K225W YesNX-5800 E450~52045W45W45WOperation panelNoNoYesNX-5800(B) KNX-5800(B) FNX-5800 K