1-4 (No.RA028)SECTION 1PRECAUTIONThis service manual does not describe PRECAUTION.SECTION 2SPECIFIC SERVICE INSTRUCTIONS2.1 SYSTEM SET-UP2.2 REALIGNMENT2.2.1 Modes2.2.2 How to Enter Each ModeMerchandise receivedChoose the type of transceiverTransceiver programmingKCT-60Connection cableKCT-36Extension cableKES-5External speakerKCT-18Ignition sense cableKES-3External speakerA personal computer, programming interface (KPG-46A/46U),and FPU (programming software) are required for programming.Frequency range (MHz) RF power Type136~174 25W NX-740 MNX-740H KNX-740H(V) K136~174136~17450W50W(Option)(Option)(Option) (Option)(Option)DeliveryMode FunctionUser mode For normal use.PC mode Used for communication between thetransceiver and PC (IBM compatible).PC programmingmodeUsed to read and write frequency dataand other features to and from thetransceiver.PC test mode Used to check the transceiver using thePC.This feature is included in the FPU.PC tuning mode Used to tune the transceiver using thePC.Clone mode Used to transfer programming datafrom one transceiver to another.User modeData programming modePC tuning modeClone modePC modePC test modeMode FunctionUser mode Power ONPC mode Received commands from PCClone mode [ ] + Power ON (Two seconds)
