Kenwood NX-900 Service Manual

Also see for NEXEDGE NX-900: Function reference Instruction manual Instruction manual

NX-90010■ Connect the KRK-10 main panel to the rearpanel with the cable8. Insert one 14-pin connector of the cable (E30-7514-15)into the connector (CN3) of the interface unit (A/2) of themain panel. ( !1 )Note: Insert the connector that has a sticker onto thecable to the connector of the main panel.9. Secure the cable bush on the main panel and fit the wa-terproof packing (orange) ( !2 ) securely over top.10.Install the molded cover ( !3 ) over the connector on themain panel and secure it with two screws ( !4 ).11.Insert the other 14-pin connector of the cable into theconnector (CN4) of the interface unit (B/2) of the rearpanel. ( !5 )12.Secure the cable bush on the rear panel and fit the wa-terproof packing (orange) ( !6 ) securely over top.13.Install the molded cover ( !7 ) over the connector on therear panel and secure it with two screws ( !8 ).Note: A cable can be connected from the left side as shownin the Figure 3-5 or from right side.However, the 14-pin connector must be connected to cor-rect direction.4. Voice Guide & Storage Unit(VGS-1: Option)4-1. Installing the VGS-1 unit in the transceiver1. Remove the cabinet, top packing and shielding plate ofthe transceiver.2. Attach two cushions to VGS-1 as shown in Figure 4. ( q )Note: Be sure not to cover the connector with the bot-tom cushion.3. Insert the VGS-1 connector (CN1) into the TX-RX unit (A/2)connector (CN595). ( w )Note: You must setup using the KPG-111D.CN4CN3 (Right side)KRK-10rear panelKRK-10main panelStickerStickerFig. 3-5CN1CN595:@Cushion(G13-1994-04)20 x 30 x 12 mmCushion(G13-1992-04)21 x 21 x 2.5 mmVGS-1Fig. 4INSTALLATION