Kenwood NX-900 Service Manual

Also see for NEXEDGE NX-900: Function reference Instruction manual Instruction manual

NX-90073.• How to enter the password with the microphone key-pad;If you press a key while “CLONE LOCK” is displayed,the number that was pressed is displayed on the trans-ceiver. Each press of the key shifts the display in orderto the left. When you enter the password and pressthe [ ] key, “CLONE MODE” is displayed if the en-tered password is correct. If the password is incorrect,“CLONE LOCK” is redisplayed.• How to enter the password with the [ ] and [ ] keys;If the [ ] and [ ] keys is pressed while “CLONE LOCK”is displayed, number (0 to 9) are displayd flashing. Whenyou press the [ ] key, the currently selected numberis determined. If you press the [ ] key after enterningthe password in this procedure, “CLONE MODE” isdisplayed if the entered password is correct. If the pass-word is incorrect, “CLONE LOCK” is redisplayed.4. Power on the slave transceiver.5. Connect the cloning cable (Part No. E30-3382-05) to themodular microphone jacks on the master and slave.6. Press the [ ] key on the master while the master dis-plays “CLONE MODE” The data of the master is sent tothe slave. While the slave is receiving the data, “PRO-GRAM” is displayed. When cloning of data is completed,the master displays “END”, and the slave automaticallyoperates in the User mode. The slave can then be oper-ated by the same program as the master.7. The other slave can be continuously cloned. When the[ ] key on the master is pressed while the master dis-plays “END”, the master displays “CLONE MODE”.Carry out the operation in step 4 to 6. Can not be clonedif the overwrite password is programmed to the slave.Note:Only the same models can be cloned together.Cloning cable(E30-3382-05)Fig. 28. Firmware Version InformationPress and hold the [ ] key while turning the transceiverpower ON and then keep pressing and holding the [ ] key,the firmware version information appears on the LCD.INSTALLATIONREALIGNMENT1. Ignition Sense Cable (KCT-46: Option)The KCT-46 is an optional cable for enabling the ignitionfunction. The ignition function lets you turn the power tothe transceiver on and off with the car ignition key.1-1. Connecting the KCT-46 cable to the transceiver1. Open the KCT-46 fuse holder and insert a mini blade fuse(3A). ( q )2. While holding a clear protective cover, remove the blackcap at the end of the yellow cable (ignition sense cable)of the transceiver. ( w )3. Connect the plug of the KCT-46 to the yellow cable ter-minal of the transceiver. ( e )4. Connect the other end of the KCT-46 to the ignition lineof the car. ( r )Note: You must setup using the KPG-111D.:@.; Ignition lineof the carF52-0019-05Fig. 1