Kenwood NXR-800 Service Manual

Also see for NEXEDGE NXR-800: Brochure Instruction manual Instruction manual Instruction manual Instruction manual

Contents

NXR-800862. Replacing Control Unit2-1. Control Unit InformationOriginal ControlUnitControl Unit(Service unit)Difference between originalunit and Service UnitX53-4130-10 X53-4130-11Mounted chip at 0-11 locationfor Service Unit.X53-4140-10 X53-4140-11Mounted chip at 0-11 locationfor Service Unit.2-2. Supplied AccessoriesItem (Including Part Number) QuantityX53-413 X53-414Control Unit (X53-413) 1 -Control Unit (X53-414) - 1KENWOOD ESN Label - 2NXDN ESN Label - 1Addendum (B59-2536-XX) 1 12-3. Printed Circuit Board DataThe following data is written on the circuit board:Data Type DescriptionFirmware NXR-700/800 FirmwareFPU Data(PC programming mode) NXR-800 Kx type data.Various Adjustment Data(PC test mode)General adjustment values for theNXR-700/800.KENWOOD ESN(X53-414 only)Model Name: NXR-700/800SType: KxThe same number as the KENWOODESN label is written.NXDN ESN (X53-414 only) The same number as the NXDN ESNlabel is written.Cut-off LineKENWOOD ESN LabelKENWOOD ESN LabelKENWOOD ESN LabelSide ViewRear ViewNXDN ESN Label (12 digits)Note: For the X53-414, a UPC code and UPC barcode isnot printed on the KENWOOD ESN Label. If necessary, cutthe label at the cut-off line and attach only the serial number.2-4. After Changing the PCB1. After changing the printed circuit board, write the up-to-date Firmware following the instructions in the “RE-ALIGNMENT 4. Firmware Programming Mode”.2. Using the KPG-109D, select your desired item (ModelName and Frequency) from the Model > Product Infor-mation menu, then use Program > Write Data to the re-peater to write the FPU data (PC Programming mode).When writing to the repeater, a Warning Message, cor-responding to the item selected, appears. Click [OK] tocontinue writing the data.3. Enter Program > Test mode, then adjust the various ad-justment data (PC Test mode) as described in the “AD-JUSTMENT”.4. For the X53-414, attach the new labels corresponding tothe new printed circuit board. (Refer to the images belowfor label placement.)5. If necessary, write the FPU data used by the customerwith the KPG-109D or KPG-110SM.Note:• When a new printed circuit board is used, the KENWOODESN changes, as does the Repeater Information displayof the KPG-109D, but this does not have any effect onthe operation of the transceiver.• If changing to the original KENWOOD ESN and NXDNESN, please contact our service center.• Re-installing other parts from original unit to Service unitis not required after changing to Service unit.TROUBLE SHOOTING