CKETCLUSTERS MONITORof nodesntesting.r she)odesidesived DXp to 10test DXDXband A or B.uster node.deSTA CON 96 BCONDUP975Each time new DX cluster data is received, the frequencydisplay is interrupted to show information as below:• The transceiver restores the frequency display afterapproximately 10 seconds pass or when you press any key.• When duplicate DX cluster data is received, the frequencydisplay is not interrupted. “dD” and a call sign will appear atthe bottom of the display.To scroll through up to 10 sets of DX information, press[LIST] twice, then press [UP]/ [DWN].• Press [OK] to access an attached comment (20 charactersmax.).• Press [LIST] to restore the frequency display.Note:uThe information is cleared when the transceiver power is turned OFF.uThis transceiver beeps each time it receives new or duplicate DXcluster data. You may access Menu 1–5–3 (BEEP) to change thissetting. The default is “ALL”. See the table on page 63.uBefore tuning to a PacketCluster node, switch the APRS Beaconfunction OFF {page 74}; otherwise, unintentional APRS packettransmission will annoy PacketCluster nodes and stations.STA CON 96 BCONDUP975CommentTimeFrequency98.12.4, 0:12 PM
