Kenwood TH-K40A Instruction Manual

Also see for TH-K40A: Manual Service manual

Contents

41• You can move the cursor to the left or right by pressing [VFO] or [MR].• Press [CALL] to delete the character at the current cursor position.• On the transceiver display, DTMF code “ ” is represented by “E” and “#” isrepresented by “F”.• When a space is entered, it becomes a “Pause” code.5 Press [F] to select the DTMF code and move the cursor to the next digit.6 Repeat steps 4 and 5 to enter up to 16 digits.7 To complete the entry, press [F] without selecting a DTMF code.8 Press [MENU] or [PTT] to exit Menu mode.TRANSMITTING A STORED DTMF CODE1 While pressing and holding [PTT], press [MONI].2 Release [MONI] (continue pressing [PTT]), then rotate the ENC control toselect the desired DTMF memory channel number (d0 ~ dF).3 While still holding [PTT], press [MONI] again to transmit the selected DTMFtones.• The code stored in the channel scrolls across the display, accompanied by DTMFtones from the speaker.• After transmitting, the frequency display is restored.• If you do not need to confirm the memory channel contents, press [STEP] (0) ~[PF] (9), [F] (A) ~ [CALL] (D), [LAMP] ( ) (E), and [ENT] (#) (F) instead of turningthe ENC control in step 2, to select a channel number. The stored DTMF code willbe immediately transmitted. (You do not need to press [MONI] in step 3.)Note: If you select an empty DTMF memory channel and press [MONI], the frequencydisplay is restored.ADJUSTING THE DTMF CODE TRANSMIT SPEEDSome repeaters may not respond correctly if a DTMF code is transmitted at fastspeed. If this happens, change the DTMF code transmit speed; the default is100 ms.1 Enter Menu mode and access Menu No. 29 (DT.SPD), then press [F].2 Rotate the ENC control to select 50/ 100/ 150 ms, then press [F] to store thesetting.3 Press [MENU] or [PTT] to exit Menu mode.