TK-218053. How to enter the password with the keypad;If you press a key while “CLONE LOCK” is displayed, thenumber that was pressed is displayed on the transceiver.Each press of the key shifts the display in order to the left.When you enter the password and press the [✳] or [S] key,“CLONE MODE” is displayed if the entered password iscorrect. If the password is incorrect, “CLONE LOCK” isredisplayed.How to enter the password with the encoder;If the encoder is rotated while “CLONE LOCK” is dis-played, numbers (0 to 9) are displayed flashing. When youpress the [C] key, the currently selected number is deter-mined. If you press the [S] key after entering the pass-word in this procedure, “CLONE MODE” is displayed ifthe entered password is correct. If the password is incor-rect, “CLONE LOCK” is redisplayed.4. Power on the slave transceiver.5. Connect the cloning cable (part No. E30-3325-05) to theuniversal connectors on the master and slave.6. Press the [S] key on the master while the master displays“CLONE MODE”. The data of the master is sent to theslave. While the slave is receiving the data, “PROGRAM”is displayed. When cloning of data is completed, the mas-ter displays “END”, and the slave automatically operatesin the User mode. The slave can then be operated by thesame program as the master.7. The other slave can be continuously cloned. When the [S]key on the master is pressed while the master displays“END”, the master displays “CLONE MODE”. Carry outthe operation in step 4 to 6.Notes:Can not be cloned if the password (over write password)is programmed to the slave.Only the same models can be cloned together.REALIGNMENT / DISASSEMBLY FOR REPAIR[C] + Power ONMINUTEHOURDAYMONTHYEAR[S][S][S][S][S]Channel selectorChannel selectorChannel selectorChannel selectorChannel selectorCompletionCloning cable(E30-3325-05)MICMICFig. 29. Clock Adjustment Mode9-1. Flow chart of operationRubber spacerRear panelTighten the circle nut, afterapplying “THREE BOND 1401”to the circle nut.DISASSEMBLY FOR REPAIR1. How to Attach the Rubber Spacer1) Press the rubber spacer with fingers and insert it betweenthe rubber spacer and the rear panel without crevice.8. Firmware Information ModeTurn the transceiver ON with the [Side1] switch helddown. Then, the version is displayed during holding the[Side1] switch.