TK-21802INTRODUCTIONSCOPE OF THIS MANUALThis manual is intended for use by experienced techni-cians familiar with similar types of commercial grade commu-nications equipment. It contains all required service informa-tion for the equipment and is current as of the publicationdate. Changes which may occur after publication are coveredby either Service Bulletins or Manual Revisions. These areissued as required.ORDERING REPLACEMENT PARTSWhen ordering replacement parts or equipment informa-tion, the full part identification number should be included.This applies to all parts : components, kits, or chassis. If thepart number is not known, include the chassis or kit numberof which it is a part, and a sufficient description of the re-quired component for proper identification.PERSONAL SAFETYThe following precautions are recommended for personalsafety:• DO NOT transmit until all RF connectors are verified se-cure and any open connectors are properly terminated.• SHUT OFF and DO NOT operate this equipment near elec-trical blasting caps or in an explosive atmosphere.• This equipment should be serviced by a qualified techni-cian only.SERVICEThis transceiver is designed for easy servicing. Refer tothe schematic diagrams, printed circuit board views, andalignment procedures contained within.GENERAL / SYSTEM SET-UPSYSTEM SET-UPMerchandise receivedChoose the type of transceiverTransceiver programmingAre you using the optional antenna?Are you using the speaker microphone?A personal computer (IBM PC or compatible), programminginterface (KPG-36), and programming software (KPG-92D) arerequired for programming.(The frequency, and signalling data are programmed for thetransceiver.)Frequency range (MHz) RF power Type 12-keyTX/RX 136~174 5W TK-2180 E YesYES KRA-22 or KRA-26NONO(Option)(Option)(Option)YES KMC-25Are you using the voice guide & storage unit?DeliveryNOYES VGS-1