TK-218063. How to Attach the VGS-11) Remove the 2 screws.2) The tip of tweezers is put into the screw hole of the coverand is pried, the cover will remove.3) Use the 2 rubber cushions and attach them to the VGS-1.4) Plug the VGS-1 into the VGS-1 connector of the PC board,pressing down on the top of the VGS-1 until secure.5) The spacer turns the adhesive surface down. Next, pushbetween the chassis and VGS-1.6) Replace the cover and tighten the 2 screws.Rubber cushion(G13-1995-04)20 x 30 x 1.0 mmRubber cushion(G13-1974-04)21 x 21 x 2.5 mmVGS-1Spacer(J30-1292-04)4.5 x 24 x 3.0 mmVGS-1VGS-1 connectorDISASSEMBLY FOR REPAIR2. How to Attach the TX-RX Unit1) In order to attach the TX-RX unit in chassis, don’t put in theTX-RX unit aslant.Please level the chassis and the TX-RX unit and attachthem.Rubber spacerRear panelTighten the circle nut, afterapplying “THREE BOND 1401”to the circle nut.1. How to Attach the Rubber Spacer1) Press the rubber spacer with fingers and insert it betweenthe rubber spacer and the rear panel without crevice.