TK-218031. Modes 2. How to Enter Each ModeMode OperationUser mode Power ONPanel test mode [A] + Power ONPC mode Received commands from PCPanel tuning mode [Panel test mode] + [S]Firmware programming mode [S] + Power ONClone mode [B] + Power ONFirmware version information [Side1] + Power ONClock adjustment mode [C] + Power ON3. Panel Test ModeSetting method refer to ADJUSTMENT.4. Panel Tuning ModeSetting method refer to ADJUSTMENT.5. PC Mode5-1. PrefaceThe transceiver is programmed by using a personal com-puter, programming interface (KPG-36) and programmingsoftware (KPG-92D).The programming software can be used with an IBM PCor compatible. Figure 1 shows the setup of an IBM PC forprogramming.REALIGNMENTUser modePanel test modeFirmware version informationPanel tuning modeData programming modePC test mode PC tuning modePC modeClone modeFirmwareprogramming modeClock adjustment modeMode FunctionUser mode For customer uses.Panel test mode Used by the dealer to check the funda-mental characteristics.Panel tuning mode Used by the dealer to tune the radio.PC mode Uses for communication between theradio and PC (IBM compatible).Data programming Uses to read and write frequency datamode and other features to and from the radio.PC test mode Uses to check the radio using the PC.This feature is included in the FPU.See panel tuning.Firmware Uses to changing the main program ofprogramming mode the flash memory.Clone mode Uses to transfer programming data fromone radio to another.Firmware version Uses to confirm the internal firmwareinformation version.Clock adjustment mode Used by dealer to adjust date and time.Fig. 1MICIBM-PCKPG-36KPG-92D