Kenwood TK-260G Service Manual

Also see for TK-260G: Instruction manual Instruction manual Service manual Service manual Service manual

Contents

TK-260G/270G2GENERAL / SYSTEM SET-UPINTRODUCTIONSCOPE OF THIS MANUALThis manual is intended for use by experienced techniciansfamiliar with similar types of commercial grade communicationsequipment. It contains all required service information for theequipment and is current as of the publication date. Changeswhich may occur after publication are covered by either ServiceBulletins or Manual Revisions. These are issued as required.ORDERING REPLACEMENT PARTSWhen ordering replacement parts or equipment information,the full part identification number should be included. Thisapplies to all parts, components, kits, or chassis. If the partnumber is not known, include the chassis or kit number of whichit is a part, and a sufficient description of the requiredcomponent for proper identification.PERSONNEL SAFETYThe following precautions are recommended for personnelsafety:l DO NOT transmit until all RF connectors are verified secureand any open connectors are properly terminated.l SHUT OFF and DO NOT operate this equipment nearelectrical blasting caps or in an explosive atmosphere.l This equipment should be serviced by a qualified technicianonly.SERVICEThis radio is designed for easy servicing. Refer to theschematic diagrams, printed circuit board views, and alignmentprocedures contained within.NOTEWE CANNOT guarantee oscillator stability when usingchannel element manufactured by other than KENWOOD orits authorized agents.Unit X57-587X-XX X54-325X-XXModel & Frequency range Remarks Helical Antenna Charger Battery 16 Keydestination 0-10 0-11 0-21 0-10TK-260G K _ – OP –M _ – 150~174MHz IF1 : 49.95MHz _ OP OP –TK-270G K _ _ LOC : 50.4MHz OP _M _ _ _ _SYSTEM SET-UPMerchandise receivedLicense and frequency allocated by FCCChoose the type of transceiverTransceiver programmingDeliveryAre you using the speaker microphone?TX/RX 150~174 5.0W TK-260G K,M TK-270G K,MFrequency range (MHz) RF power TypeA personal computer (IBM PC or compatible), programminginterface (KPG-22), and programming software (KPG-56D)are required for programming.(The frequency, TX power HI/LOW, and signalling data are programmedfor the transceiver.)YESNOKMC-17 or KMC-21Speaker microphone(Option)