Kenwood TK-3000 Service Manual

Also see for TK-3000: Instruction manual Quick manual Instruction manual Instruction manual Instruction manual

Contents

TK-30003SYSTEM SET-UPREALIGNMENT1. ModesMode FunctionUser mode For normal use.PC mode Used for communication between the trans-ceiver and PC.Data programmingmodeUsed to read and write frequency data andother features to and from the transceiver.PC test mode Used to check the transceiver using the PC.This feature is included in the FPU.Clone mode Used to transfer programming data fromone transceiver to another.2. How to Enter Each ModeMode OperationUser mode Power ONPC mode Received commands from PCClone mode [PTT]+[Side]+Power ON (Two seconds)3. PC Mode3-1. PrefaceThe transceiver is programmed by using a personal com-puter, a programming interface (KPG-22/22A, USB adapter(KCT-53U)) and FPU (programming software).The programming software can be used with a PC. Fig-ure 1 shows the setup of a PC for programming.3-2. Connection Procedure1. Connect the transceiver to the personal computer withthe interface cable and USB adapter (when the interfacecable is KPG-22A, the KCT-53U can be used).Choose the type of transceiverTransceiver programmingDeliveryAre you using the speaker microphone?A personal computer, programming interface (KPG-22/22A),and FPU (programming software) are required for programming.(The frequency, TX power HI/LOW, and signaling data areprogrammed for the transceiver.)YESNOKMC-21 or KMC-45Speaker microphone(Option)Are you using the optional antenna? YESNOTX/RX 440~480 4.0W TK-3000 K,MFrequency range (MHz) RF power TypeMerchandise receivedOptional antennaKRA-23 or KRA-27TX/RX 400~430 TK-3000 M2User modeData programming modePC test mode PC tuning modePC modeClone mode