Kenwood TK-3201 Service Manual

Also see for ProTalk TK-3201: Instruction manual Service manual supplement Service manual

Contents

TK-32014DISASSEMBLY FOR REPAIR■ Removing the case assembly from the chassis.1. Remove the volume knob z and channel knob x.2. Remove the two screws c.3. Lift and remove the chassis from the case assembly v.(Use a flat-blade screwdriver to easily lift the chassis.)■ Removing the TX-RX unit from the chassis.1. Remove the packing b from the SP / MIC jack of the TX-RX unit.2. Remove the eleven screws n fixing the TX-RX unit.3. Remove the fixing bracket m of the SP / MIC.4. Remove the solder of the antenna terminal with a solderingiron ,.5. Remove the solder of the positive terminal with a solderingiron ..Note: You can remove the TX-RX unit from the chassis withoutremoving the solder at the positive terminal. However,in this case, you can not attach the packing (G53-1605-03) that is on the positive terminal to the chassis inassembling. So, it is advisable to remove the solder onthe positive terminal first.6. Remove the FPC from the flat cable connector /.7. Lift and remove the TX-RX unit from the chassis Ω.1334296 6 66 61156667108■ Removing the battery release lever from the caseassembly.1. Press the upper part of the lever toward the inside of thecase assembly. One side of the shaft will be removed z.2. Lift and remove the battery release lever from the caseassembly x.■ Attaching the battery release lever to the caseassembly.1. Insert one side of the shaft into the hole at the lever fittingsection on the case assembly z.Caution : The thin spring (G01-4543-04) should be positionedabove the two tabs of the lever.2. Tilt the battery release lever slightly forward x, so that thethick spring (G01-4542-04) is positioned below the casesurface.3. With the thick spring positioned below the case surface,attach the other side of the shaft to the case assembly bypressing the battery release lever c until it snaps into placev.Caution : Be careful not to tilt the battery release lever tooforward.If the battery release lever is pushed in this statewhere the two tabs come below the case surface,there is a possibility of damaging the two tabs.211324A thin springShaftTwo tabsA thick spring