Kenwood TK-5210 Modification Information

Also see for TK-5210: Specifications Instruction manual Specifications Instruction manual Service manual

2 CONNECTING THIRD PARTY OPTIONAL DEVICESMOD (K)/Ver. 1.04 Confidential Contents 112. Select Edit menu > “Extended Function”.The Extended Function window appears on thedisplay.3. Select “ANI Board” from the Optional Boarddropdown list.Refer to the ANI Board’s instruction manual forinstructions on how to configure the ANI Board.4. Write configuration data to the transceiver.Refer to the Field Programming Reference forinstructions on how to write the configuration data tothe transceiver.2.3 Man-down Tilt Switch forEmergency ModeThe Man-down Tilt Switch can be installed in thetransceiver. This section describes how to install theMan-down Tilt Switch in the TK-5120. Items Required for Installation• Transceiver• Man-down Tilt Switch *1• Cushion• Attached heat shrink tube• 2 cables (blue and black)*1 The Cimarron CAE-3 is used in this example.2.3.1 Configuring and Modifying theMan-down Tilt Switch1. Prepare the Man-down Tilt Switch.2. Cut cables (blue and black) to approximately2" (50 mm).3. Solder the cables (black and blue) to the positionshown in the figure.3. Install the heat shrink tube (black, approx. 10 mm) onthe blue cable side in order to hide the soldered part.Remove the battery pack to install the Man-down TiltSwitch.2" (50 mm)1/8"(3 mm)1/8"(3 mm)Heat shrink tubeBlueBlack

/ 18

Related manuals for Kenwood TK-5210