Kenwood TK-5210 Modification Information

Also see for TK-5210: Specifications Instruction manual Specifications Instruction manual Service manual

2 CONNECTING THIRD PARTY OPTIONAL DEVICES12 Contents Confidential MOD (K)/Ver. 1.042.3.2 Installing the Man-down TiltSwitch in the TK-52101. Remove the 4 screws that hold the cover in place.2. Insert tweezers into the cover screw hole and pull offthe cover.3. Solder the Man-down Tilt Switch to the TX-RX PCB(X57-6820-10).Connect the 2 cables from the Man-down Tilt Switchto the position shown in the following figure.4. Install the sheet and cushion in the transceiver.G11-2572-04 (13 mm x 7 mm x 0.188 mm) can beused for the sheet.G13-2070-04 (Boron 12 mm x 7 mm x 3 mm) can beused for the cushion.Install the sheet and cushion by inserting them into thelocation where the blue wire is soldered, aligning incenter.Be careful not to damage the seal between the transceiverand its cover. Damaging the seal may degrade thewaterproof performance of the transceiver.Solder theblue wire(center) here.Solder theblack wire(outside) here.CushionSheetBlue wire

/ 18

Related manuals for Kenwood TK-5210