Kenwood TK-5310 K4 Service Manual

Also see for TK-5310: Specifications Instruction manual Specifications Instruction manual

Contents

TK-53106REALIGNMENT8. Self Programming Mode(K2, K3, K5 and K6 models only)Write mode for frequency data and signaling etc. To beused ONLY by the authorized service person maintaining theuser's equipment. After programming, reset the FPU to the"Self- Programming" disabled mode. Transceivers CANNOTbe delivered to the end-user in the self-programming mode.The following setup items in the channels programmed bythe FPU can be changed using the self-programming mode.The addition of new channel and the deletion of channel thathas already been programmed by the FPU cannot beperformed using the self-programming mode.• RX frequency• TX frequency• Channel type• TX mode (When the channel type is selected "MIXED".)• Channel spacing• RX signaling• TX signaling• RX NAC• TX NAC• Talkgroup list numberNote:The personality will be also changed when the above-mentioned items is changed. (Refer to the FPU for thepersonality details.)Key guide on the "INPUT PASSWORD" display.• CNF([A] key): The password confirmation• DEL([B] key): Delete the least digit from the current pass-word number (Press and hold to delete allpassword numbers)• SET([D] key): Determine the least digit of the passwordnumber8-1. Enter to the self programming modePress and hold the [Side2] and [PTT] keys while turningthe transceiver power ON and then release the [PTT] keyfirst. Ignoring whether the Read authorization password isset or not, "INPUT PASSWORD" appears.If the Read authorization password is not set to the trans-ceiver, "SELF PROG MODE" is displayed on the LCD when the[A] key is pressed while "INPUT PASSWORD" is displayed.If the password is set to the transceiver, "SELF PROGMODE" is displayed on the LCD when you enter the correctpassword while "INPUT PASSWORD" is displayed.For the password input method, see "7. Clone Mode”step 3 described on page 5.Note :This mode (self programming mode) cannot be set whenit has been disabled with the FPU.8-2. Data WritingIf the [Side3] key is pressed while Zone/Channel mode isdisplayed, new data is written into memory. "Writing" is dis-played while the transceiver is writing data.No. Setup item Display Remarks1 Select ZONE [**] -CH *** Zone : 1~50Zone/Channel ZONE ** -CH [***] CH : 1~2502 RX frequency RX Freq Receive frequency3 TX frequency TX Freq Transmit frequency4 Channel type CH Type ANALOG/P25/MIXED5 TX mode TX Mode ANALOG/P256 Channel spacing CH Space 25.0kHz/12.5kHz (When the Channel type is selected "ANALOG" or "MIXED".)P25 12.5kHz/12.5kHz (When the Channel type is selected "P25".)7 RX Signaling RX Sig Receive QT/DQT8 TX Signaling TX Sig Transmit QT/DQT9 RX NAC RX NAC *** 000~FFF (Hexadecimal) Note : “F7F” cannot be set.10 TX NAC TX NAC *** 000~FFF (Hexadecimal) Note : “F7E” and “F7F” cannot be set.11 Talkgroup list number TG List No. *** 1~250The setup items for self programming mode are as follows.