Kenwood TK-7100H Service Manual

Also see for TK-7100H: Specifications Service manual

TK-7100H96. Accessory Connection Cable (KCT-39)The KCT-39 is an accessory connection cable for connect-ing external equipment. The connector has 15 pins and thenecessary signal lines are selected for use.6-1. Installing the KCT-39 in the Transceiver1. Lift the DC cord bushing ( 1 ) from the chassis. Peel thepad as shown in Figure 3 ( 2 ).1234CN2CN3AB7865ChassisChassisCushionKCT-39sumi tubePCBFace downAvoid forming the wiring towardsthe shielding cover closure area.Wire harnessband (Stopper)End view of this area9 101315 13Fig. 32. Stick the pad to the DC cord ( 3 ) and chassis ( 4 ), bothof which are supplied with the KCT-39.3. Insert the KCT-39 cable ( 5 ) into the chassis ( 6 ). Thewire harness band ( 7 ) must be inside the chassis andface down.4. Connect the KCT-39 to the TX-RX unit as shown in Figure5 ( 8 ).5. Connect the KCT-39 to the external accessory by insertingthe crimp terminal ( 9 ) into the square plug ( 10 ), both ofwhich are supplied with the KCT-39.Fig. 4Fig. 5Fig. 6147101325811143691215No. Color Internal Nameconnector1 Red CN2-1 SB2 Pink CN3-1 IGN3 Black CN2-3 GND4 Brown CN3-3 DETO5 Orange CN3-2 DATAI6 Yellow CN2-8 FNC47 Green CN2-7 FNC38 Blue CN2-9 FNC5No. Color Internal Nameconnector9 Purple CN2-12 FNC810 Gray CN2-10 FNC611 White CN2-11 FNC712 NC NC13 NC NC14 Sky blue CN2-6 FNC215 Turquoise CN2-5 FNC1■ Accessory Port FunctionREALIGNMENT