Kenwood TK-7100H Service Manual

Also see for TK-7100H: Specifications Service manual

TK-7100H64-1. Adding the data password.If the data password is set in the optional feature menu,you must enter the password (Master transceiver) to activatea clone mode.You can use 1, 2, 3, and 4 to configure the password. Themaximum length of the password is 6 digits.1. [CH DOWN]+Power ON.2. “CLN LOCK” is displayed on the LCD.3. Enter the password using 1 : [MON] key, 2 : [SCN] key, 3 :[ ] key and 4 : [ ] key.4. Press [CH DOWN] key.5. If the password matches, the transceiver enters a clonemode and “ CLONE ” is displayed. Otherwise, trans-ceiver beeps and returns to the password input mode.Clone cable(E30-3382-05)Fig. 2Press [CH DOWN] key+Power ON for 2 secondsIs datapasswordset?YesNo Shows CLN LOCKInput passward ifpassward is correctClone mode[MON]Start the clone function5-2. Adding the Data PasswordIf the data password is set in the optional feature menu,you must enter the password to activate a self programmingmode.You can use 1, 2, 3 and 4 to configure the password. Themaximum length of the password is 6 digits.1. [MON]+Power ON.2. “SELFLOCK” is displayed on the LCD.3. Enter the password using 1 : [MON] key, 2 : [SCN] key, 3 :[ ] key and 4 : [ ] key.4. Press [CH DOWN] key.5. If the password matches, the transceiver enters a self pro-gramming mode and “ SELF ” is displayed. Otherwise,transceiver beeps and returns to the password inputmode.Note :This mode (self programming mode) cannot be set whenit has been disabled with the FPU.5-3. Channel Setting ModeEach channel can be setup in its action mode by using thepanel keys.• Pressing [MON] when “ SELF ” is displayed, sets chan-nel setting mode.• Select an item set using [ ] then change the selectionwith the [CH UP] or [CH DOWN].• The data displayed using [SCN] is stored in the memoryand then proceeds to the next item.• Pressing [ ] proceeds to the next item without storing itin the memory.• Press [MON] to set the display to “ SELF ” and return toreset (default) status.The setup items for channel setting mode are listed be-low.No. Function Choices Display RemarksSelect 1~64 key : Group/Channelchannel selectionSelect 1~8 key : Group/Channelgroup selection1 RX Step 2.5kHz~ Display when an itemfrequency 1MHz is selected or a step ischanged (about 0.5seconds).key : Select thefrequency stepBlank key : Hold 1 second100.0000~ to frequency on/blank550.0000MHz switching.The right most dotindicates 50Hz digit.(On=5, Off=0)5. Self Programming ModeWrite mode for frequency data and signalling, etc. To beused ONLY by the authorized service person maintaining theuser’s equipment. After programming, reset the FPU to the“Self- Programming” disabled mode. Radios CANNOT bedelivered to the end-user in the self-programming mode.5-1. Enter to the Self Programming ModeHold down the [MON] key and turn the power switch on.When enter the self programming mode, “ SELF ” is dis-played.■ Flow Chart (Master radio)REALIGNMENT1 – 1 .1 – 6 4 .1 . – 18 . – 1S T P 2 5 0S T P 1 MR . – – – – – – –R.150.0000