Kenwood TK-7100H Service Manual

Also see for TK-7100H: Specifications Service manual

TK-7100H5REALIGNMENT1. ModesUser mode PC mode PC programming modeClone mode PC test mode PC tuning modeSelf programming modeMode FunctionUser mode For normal use.PC mode Used for communication between theradio and PC (IBM compatible).PC programming Used to read and write frequency datamode and other features to and from the radio.PC test mode Used to check the radio using the PC.This feature is included in the FPU.PC tuning mode Used to tune the radio using the PC.Clone mode Used to transfer programming data fromone radio to another.Self programming You can program the frequency, signallingmode and other functions using only the radio.2. How to Enter Each ModeMode OperationUser mode Power ONPC mode Received commands from PCClone mode [CH DOWN]+Power ON (Two seconds)Self programming mode [MON]+Powr ON (Two seconds)3. PC Mode3-1. PrefaceThe TK-7100H transceiver is programmed using a per-sonal computer, a programming interface (KPG-46) and pro-gramming software (KPG-80D).The programming software can be used with an IBM PCor compatible. Figure 1 shows the setup of an IBM PC forprogramming.3-2. Connection Procedure1. Connect the TK-7100H to the personal computer with theinterface cable.2. When the Power is switched on, user mode can be en-tered immediately. When the PC sends a command, theradio enters PC mode.When data is transmitted from transceiver, the TX indica-tor blink.When data is received by the transceiver, the BUSY indi-cator blink.In the PC mode, “ PC ” is displayed on the LCD.3-3. KPG-46 Description(PC programming interface cable : Option)The KPG-46 is required to interface the TK-7100H to thecomputer. It has a circuit in its D-subconnector (25-pin) casethat converts the RS-232C logic level to the TTL level.The KPG-46 connects the modular microphone jack of theTK-7100H to the computers RS-232C serial port.3-4. Programming Software DescriptionKPG-80D is the programming software for TK-7100H sup-plied on three 3.5” floppy diskettes. This software runs un-der Windows 98, ME, Windows 2000 or XP on an IBM-PC orcompatible machine.The data can be input to or read from TK-7100H and editedon the screen. The programmed or edited data can beprinted out. It is also possible to tune the transceiver.4. Clone ModeProgramming data can be transferred from one radio toanother by connecting them via their modular microphonejacks. The operation is as follows (the transmit radio is themaster and the receive radio is the slave).Note :Clone mode should be enabled.1. Turn the master TK-7100H power ON with the [CHDOWN] key held down (2 seconds), “ CLONE ” is dis-played on the LCD.2. Power on the slave TK-7100H.3. Connect the cloning cable (No. E30-3382-05) to the modu-lar microphone jacks on the master and slave.4. Press the [MON] key on the master TK-7100H transceiver.The data of the master is sent to the slave. While themaster is sending data, [TX] icon blinked. While the slaveis receiving the data, “ PC ” is displayed and [BUSY] iconblinked. When cloning of data is completed, the masterdisplays “END”, and the master [TX] icon turned off, andthe slave automatically operates in the User mode. Theslave can then be operated by the same program as themaster.5. The other slave can be continuously cloned. Carry out theoperation in step 2 to 4.Fig. 1IBM-PCKPG-46TK-7100HKPG-80D